You know, if Canada is going to treat disfavored political dissidents like terrorists, then the government shouldn't be surprised when said political dissidents start acting like terrorists.
Did you know that the active roster of the IRA never numbered over a thousand during the entire time the IRA was actively committing terrorist incidents?
Canada needs to think about that. HARD
Should any insurgency flare up in Canada, the worlds largest supplier of private arms is just across a 2 thousand mile virtually unmonitored border... This is without even considering the modern reality of 3D printers.
You know, if Canada is going to treat disfavored political dissidents like terrorists, then the government shouldn't be surprised when said political dissidents start acting like terrorists.
Did you know that the active roster of the IRA never numbered over a thousand during the entire time the IRA was actively committing terrorist incidents?
Canada needs to think about that. HARD
Should any insurgency flare up in Canada, the worlds largest supplier of private arms is just across a 2 thousand mile virtually unmonitored border... This is without even considering the modern reality of 3D printers.
Guns are hard to actually 3d print, but double stack stanag's are easy.
You can even increase their reusability by using metal springs bent from wire, which can be easily smugglable due to being an unbannable component.
Look up FGC-9 MKII, fully capable of being manufactured at home, including the barrel.
Ammunition is the difficult part to make at home, particularly primers.